Introduction A leading lubrication company aimed to launch new products in the thermic fluid line. While they had a strong reputation in the lubricant oil market, their sales team lacked familiarity with the specific terminology … Read more
Introduction A company approached Dr. Thermic Fluid – EXIMIOUS with a thermic fluid report indicating critical parameters. Despite the oil being relatively new, the situation required immediate attention. Eximious explained the process of a naked-eye … Read more
Introduction A multinational company that manufactures inks, resins, and varnishes faced challenges with its multiple thermic fluid systems. These systems had a common expansion tank and separate deaerators, holding a total of approximately 150,000 liters … Read more
Introduction A major chemical company faced a critical issue with their thermic fluid system when the flash point dropped significantly to 120°C. This decline was traced back to the blending of low-boiling process chemicals, specifically … Read more
Introduction A large petrochemical complex faced a significant issue when the Total Acid Number (TAN) of their synthetic specialized-grade imported thermic fluid increased alarmingly from 0.5 to 1.8 within just three months due to external … Read more
Introduction A plywood manufacturer received a thermic fluid sample report indicating a high Total Acid Number (TAN) exceeding 2.5, along with elevated carbon levels. Concerned about the implications of increased acidity—such as pipeline punctures, metal … Read more
Introduction A leading textile company planned to expand its existing plant, which already had two heaters. Although the heater efficiency was measured by the manufacturer, there was a noticeable gap between heat generation and utilization. … Read more
Introduction In the flexible packaging industry, a manufacturer specializing in snack packaging films faced a critical decision regarding their pumping system. The team considered removing an existing booster pump to minimize maintenance requirements. The Vice … Read more
Introduction A plywood manufacturer received a thermic fluid sample report indicating a carbon content more than 2.5, TAN more than 2.3 but viscosity was under control. Concerned about the implications of higher carbon content and … Read more
Introduction A textile processor in Bhilwara faced a challenge: their thermic fluid had turned black and become highly viscous, with an analysis revealing approximately 11% total carbon content. Although the oil remained flowable at room … Read more