Introduction A leading textile company planned to expand its existing plant, which already had two heaters. Although the heater efficiency was measured by the manufacturer, there was a noticeable gap between heat generation and utilization. ... Read more

Introduction In the flexible packaging industry, a manufacturer specializing in snack packaging films faced a critical decision regarding their pumping system. The team considered removing an existing booster pump to minimize maintenance requirements. The Vice ... Read more

Introduction A plywood manufacturer received a thermic fluid sample report indicating a carbon content more than 2.5,  TAN more than 2.3 but viscosity was under control. Concerned about the implications of higher carbon content and  ... Read more

Introduction A textile processor in Bhilwara faced a challenge: their thermic fluid had turned black and become highly viscous, with an analysis revealing approximately 11% total carbon content. Although the oil remained flowable at room ... Read more

Introduction A fibre manufacturing company faced a critical challenge: when heating stopped, the thermic fluid quickly became viscous, resembling curd. There was no alternative but to replace the oil. With stringent production schedule, minimizing downtime ... Read more

A leading textile manufacturer noticed a drop in performance as the temperature across their stenter radiator decreased, heat transfer efficiency declined, and moisture removal was inadequate.