Thermic fluid Pump
Home / Thermic fluid Pump | Condensate pump | Hot water Pump | Boiler Feed water pump
MACSTAR HOTPACK
Hotpack™ is the ultimate Thermic fluid pump / Hot fluid pump packing in set form. Gone are the days of leaking pump beyond control. Forget about installing expensive mechanical seal.
Advantages of Hot Pack™ are
- Absolute control on leakages
- Pump runs cooler.
- Easy on shaft, No shaft damage.
- Very long gland life.
- No need to replace the entire set, just add one more ring if required.
- Convenience - ready to use gland in correct size.
- Reduces inventories - saves energy.
WHAT COST ARE LEAKAGES???.. NOT PACKINGS
LEAKAGE DATA FROM PCRA
| LEAKAGE RATE/ shift | : | LEAKAGE LOSS |
| One Drop Per Second | : | 1.5 Liters |
| Two Drops Per Second | : | 4 Liters |
| Stream Breaks into Drops | : | 30 Liters |
| 1.5 mm Stream | : | 106 Liters |
| 3 mm S | : | 333 Liters |
| 4.5 mm STREAM | : | 545 Liters |
| 6.5 mm STREAM | : | 1180 Liters |
Applications
HOT PACK™ can be used to pack Thermic fluid pumps, Hot water pumps, Condensate pumps or Boiler feed water (heated) pump. Can be supplied in any required size.
CASE STUDY
Earlier packing used was Graphite / Asbestos or packing in ALUMINIUM foil. Leakage rate was @ 40 - 60 drops per minute. Shaft/Sleeve scoring was found. Life was @ 25 - 30days. After replacing this with HOTPACK, leakage was reduced to 2 drops / min. AND PAYBACK WAS 15 DAYS.